To Next PageTo Next Page
Need help?Do you have a question about the Franke HCMF-30 and is the answer not in the manual?
Details key performance metrics including model, part number, capacity, refrigeration type, and agency listings.
Specifies voltage, phase, cycles, amperage, watts, and power cord details for the freezer units.
Identifies the unit's temperature display and control interface.
Details temperature range, cut-out/cut-in points, differential, and compressor protection settings.
Details the cut-out setting and differential for the high-pressure safety switch.
Specifies the cut-out setting and differential for the defrost high limit safety.
Illustrates the wiring harness connections for both HCMF-18 and HCMF-30 models.
Addresses issues where the unit's main power is not active, checking breaker, cord, and switch.
Covers scenarios where power is on, but the freezer fails to operate, checking controller and connections.
Diagnoses issues with the freezer not cooling and the temperature display being off, checking controller state.
Addresses lack of cooling despite temperature display, checking set point, gaskets, fans, and ice buildup.
Diagnoses problems with the condensing unit not starting or tripping on overload, checking coil cleanliness and components.
Details possible causes and checks for 'Probe 1 Faulty' error, including probe damage and wiring.
Explains 'Probe 2 Faulty' error, covering probe damage, wiring, and replacement recommendations.
Describes 'High Probe Temperature' alarm, its cause, and when to wait for value stabilization.
Covers 'Low Probe Temperature' alarm, its cause, and typical probe failure diagnosis.
Critical warning to unplug the unit before servicing electrical components or access panels.
Details key performance metrics including model, part number, capacity, refrigeration type, and agency listings.
Specifies voltage, phase, cycles, amperage, watts, and power cord details for the freezer units.
Identifies the unit's temperature display and control interface.
Details temperature range, cut-out/cut-in points, differential, and compressor protection settings.
Details the cut-out setting and differential for the high-pressure safety switch.
Specifies the cut-out setting and differential for the defrost high limit safety.
Illustrates the wiring harness connections for both HCMF-18 and HCMF-30 models.
Addresses issues where the unit's main power is not active, checking breaker, cord, and switch.
Covers scenarios where power is on, but the freezer fails to operate, checking controller and connections.
Diagnoses issues with the freezer not cooling and the temperature display being off, checking controller state.
Addresses lack of cooling despite temperature display, checking set point, gaskets, fans, and ice buildup.
Diagnoses problems with the condensing unit not starting or tripping on overload, checking coil cleanliness and components.
Details possible causes and checks for 'Probe 1 Faulty' error, including probe damage and wiring.
Explains 'Probe 2 Faulty' error, covering probe damage, wiring, and replacement recommendations.
Describes 'High Probe Temperature' alarm, its cause, and when to wait for value stabilization.
Covers 'Low Probe Temperature' alarm, its cause, and typical probe failure diagnosis.
Critical warning to unplug the unit before servicing electrical components or access panels.
General
