How to troubleshoot a Franke Freezer that does not run?
If your Franke Freezer isn't running, first ensure the rocker switch is in the ON position. If that's not the issue, check if the electronic controller has been turned off by pressing and holding the power button (located in the top-right corner of the controller) for 5-7 seconds. Lastly, verify that the circuit breaker hasn't tripped and reset it if necessary.
What to do if the product in my Franke HCWF-P Freezer is above the target temperature?
If the product in your Franke Freezer is above the target temperature, it might be due to a high ambient temperature in the store. In this case, decrease the set point temperature of the controller. Also, ensure that all food is pre-chilled in cold storage to safe food limits before placing it in the drawers.
Why is my Franke HCWF-P Freezer running, but not reaching target operating temperatures?
If your Franke Freezer is running but not reaching the target operating temperatures, it could be due to several reasons. The store's ambient temperature might be too high, requiring you to decrease the set point temperature of the controller. Another cause could be a dirty or clogged condenser coil, which you should clean with a soft bristle brush. Finally, ice buildup on the evaporator coils can also prevent the unit from reaching the desired temperature. In this case, remove all product, defrost, and allow sufficient time for the unit to reach the target operating temperature.
What to do if there is frost building up on the door of my Franke HCWF-P?
If you notice frost building up on the opening around the door of your Franke Freezer, it's likely that the door gasket is damaged or not installed correctly. Check the door gasket to make sure it is correctly installed and is not cracked or damaged.
Details the meaning of hazard symbols used in the manual for clear understanding of risks and warnings.
Provides critical instructions for safe operation and maintenance to prevent injury or death.
Identifies and lists the main parts of the High Capacity Wall Freezer with a diagram and part names.
Step-by-step instructions for physically mounting the wall freezer unit, including wall preparation.
Procedure to change the swing direction of the freezer door for installation flexibility.
Locates and explains the function of the main power switch for the unit.
Details factory set temperatures and the adjustable temperature range for the freezer.
Instructions on how to modify the freezer's temperature using the digital controller.
Steps to initiate manual defrosting, though automatic defrost is standard.
Guide on how to adjust or change the positions of the wire shelves inside the freezer.
Recommendations for loading products to ensure proper air circulation and temperature.
To Next Page
General
