Franke PROFESSIONAL Series User Manual

24
COOKING ADVICE
PAN QUALITY
Accepted materials: steel, enameled steel, cast iron, ferromagnetic stainless-steel, aluminum with
ferromagnetic bottom.
Not accepted materials: aluminum and stainless-steel without ferromagnetic bottom, copper, brass, glass,
ceramic, porcelain.
The manufacturers specify if their products are compatible induction.
To check if pans are compatible :
• Put a little water in a pan placed on an induction heating zone set at level [ 9 ].This water must
heat in a few seconds.
• A magnet sticks on the bottom of the pan.
Certain pans can make noise when they are placed on an induction cooking zone. This noise doesn’t mean any failure on the appliance and
doesn’t influence the cooking operating.
PAN DIMENSION
The cooking zones are, up to a certain limit, automatically adapted to the diameter of the pan. However the bottom of this pan must have a
minimum of diameter according to the corresponding cooking zone.
To obtain the best efficiency of your cooktop, please place the pan in the centre of the cooking zone.

Franke PROFESSIONAL Series Specifications

General

Brand	Franke
Model	PROFESSIONAL Series
Category	Cooktop
Language	English