200560triR03 0608
SAFETY WARNINGS
BEFORE OPERATING OR
INSTALLING THIS PUMP,
READ THIS MANUAL AND
FOLLOW ALL SAFETY
RULES AND OPERATING
INSTRUCTIONS.
A ground fault interrupter (GFI) protected circuit is rec-
ommended for use with any electrical device operating
in or near water.
Have a licensed and qualifi ed electrician provide
electrical power to the pump.
Make sure the line voltage and frequency of the
electrical current supply matches the specifi cations
printed on the pump nameplate.
Ensure the pump and electrical supply system
are properly grounded. Never install or test a
pump without proper electrical grounding of the
system.
Always disconnect pump from power source before handling
or servicing.
This product is furnished with a 3-prong plug for grounding;
connect only to properly grounded receptacle.
NEVER UNDER ANY CIRCUMSTANCES REMOVE OR
DISABLE THE GROUND PLUG.
Keep electrical plug dry - do not lift pump using cord.
Not investigated for use in swimming pools.
WARNING - ELECTRICAL PRECAU-
TIONS
All wiring, electrical connections, and system
grounding must comply with the National Electri-
cal Code (NEC) and with any local codes and
ordinances. Employ a licensed electrician.
WARNING - RISK OF ELECTRICAL
SHOCK
• Have an electrician provide electrical power to
motor.
• A ground fault interrupter (GFI) protected circuit is
recommended for use with any electrical device
operating near water.
Float switch for single
phase automatic
models only! Switch
cord with piggyback
grounded plug.
Pump and motor
assembly.
Power cord with grounded
plug,
SAFETY
CAREFULLY READ THESE
SAFETY MESSAGES IN THIS
MANUAL AND ON PUMP.
CAUTION
• Review instructions before operating.
Grounded plug
115 volt confi gu-
ration.
NOTE:
For automatic built-in fl oat
switch models, both the
power and switch cords use
the same grounded plug.
SUBMERSIBLE
EFFLUENT & SEWAGE PUMPS
RL SERIES
To Next Page
General
