Franklin Electric submonitor User Manual (English)

Other manuals for Franklin Electric submonitor

Questions and Answers:

J
Joshua MendezSep 7, 2025
Why does my Franklin Electric submonitor Protection Device overheat?
- A
  Angela DanielsSep 7, 2025
  Several factors can cause your Franklin Electric Protection Device to overheat. Check and stabilize the line voltage if it's too high or too low. Reduce the load on the motor if it is overloaded. Balance the current across all phases if there's excessive current unbalance. Also, improve cooling around the motor and reduce the water temperature if it's too high. Finally, if there's excessive electrical noise (like from a VFD nearby), move the VFD away from sensitive components.
A
audrey25Sep 8, 2025
What causes an Underload on a Franklin Electric submonitor Protection Device and what to do?
- S
  Steve HurstSep 8, 2025
  An underload on your Franklin Electric Protection Device can stem from several causes. The SF Max Amps setting might be incorrect, so adjust it accordingly. If the well is being over-pumped, reduce the pumping volume. Check for a clogged pump intake and clear it. Ensure the valve is open. Tighten the pump impeller if it's loose. Repair or replace any broken shaft or coupling. Finally, check for phase loss.
C
Chris GeorgeSep 10, 2025
What causes Unbalance in Franklin Electric submonitor?
- B
  Breanna MarshallSep 10, 2025
  Unbalance in your Franklin Electric Protection Device can be due to a few reasons. Check for phase loss. Investigate and correct any power supply imbalance. Also, inspect, repair, or replace the open delta transformer if there is one.
A
andrew48Sep 12, 2025
What to do if my Franklin Electric submonitor Protection Device is experiencing Phase Reversal?
- A
  ayalastevenSep 12, 2025
  If your Franklin Electric Protection Device is experiencing phase reversal, it's likely due to an incoming power problem. Check the incoming power connections and phase sequence to resolve this.
J
Jessica KennedySep 13, 2025
What causes False Starts in a Franklin Electric submonitor Protection Device?
- S
  stephen06Sep 13, 2025
  False starts in your Franklin Electric Protection Device can be caused by chattering contacts, which should be inspected and replaced. Also, ensure that all connections in the motor power circuit are secure. Finally, replace any arcing contacts.

Franklin Electric submonitor Specifications

General

Frequency	50/60 Hz
Enclosure Rating	NEMA 4X
Operating Temperature	-40°C to 70°C
Storage Temperature	-40°C to 85°C
Protection Type	Phase Loss, Phase Reversal

Related product manuals

SUBMONITOR CONNECT Series

232 pages

SUBMONITOR CONNECT MT1111

232 pages

SUBMONITOR CONNECT MT2211

232 pages

Franklin Electric submonitor Installation & Operation Manual

Table of Contents

Other manuals for Franklin Electric submonitor

Questions and Answers:

Franklin Electric submonitor Specifications

Related product manuals