Franklin Technology C Spire - Insert Your 4 G LTE SIM Card

3
① Color LCD display
6 icons /
4 display lines for
alphanumeric character
display
The display has (6) icons on the top, including signal strength,
4G/3G service indicator, alert message, GPS, connected
devices, and battery status. Under the icon line, the display
has a display area for (4) lines of alphanumeric character
display. To save power, the display automatically turns off in
10 seconds unless any function key is pressed by users.
② Charging status
LED
Red/Green
When the battery is being charged, the LED illuminates a red
light. When the battery is fully charged, the LED color
changes to green.
③ Micro USB
Connector
Charging
Connect the charger cable to the micro USB port to charge the
battery.
④ Alert / Clear Button
Press once
Press & Hold
Press once to display alert messages. Press and hold the
button to delete the message displayed.
⑤ Information Button
Press once
Press & Hold
Press once to display data usage information. Press and hold
to reset the data usage information. Press short again to
display SSID. Press short again to display Wi-Fi security key.
⑥ Power Button
Press & Hold
Press and hold the button to turn on or to turn off your 4G
LTE Mobile Hotspot
Insert Your 4G LTE SIM Card
Please ensure that the C Spire 4G LTE SIM card has been inserted prior to use.
1. Lift and open the battery cover.
2. Insert the SIM card as shown in the picture below.
Button/Connector
Description
① SIM card slot
The 4G LTE SIM card is installed here.
② Battery compartment
The battery is installed in the compartment.
③ Master reset button
Insert a paper clip into the hole and press and hold to reset the device to factory
settings.
④ Battery removal divot
Lift the battery cover here