BASIC FAULT FINDING
If your scooter will not start:
(1) Check the power key switch is turned "on". If it is, the battery condition indicator
meter will be operating. If the green status light on your console is flashing once
per second, charge your batteries.
If the battery condition meter and the green status light fail to operate when the key switch is
in the "on" position, check the following:
(2) Make sure the battery charger is not plugged into the tiller charge socket, this will
prevent drive.
(3) Check both battery connectors. Check battery terminal condition.
(4) Check the "circuit breaker".
If your scooter stops for no apparent reason, it is probably due to the circuit breaker
disconnecting from the speed control electronic box.
On rare occasions, a temporary overload on the electric circuit can occur – for instance when
climbing a steep incline. If this happens, reset the circuit breaker, wait for two minutes to
allow the temperature activated switch to cool down. Locate the plunger on the circuit breaker
through the access hole. Place a nger onto the circuit breaker and press down on the plunger
until it remains down. You are now ready to drive again. If the circuit breaker trips up again
wait for 5 minutes and try again.
1. Fault Diagnosis:
Faults with the main speed controller are rare. Most faults on powered vehicles are associated
with wiring or misconnections due to poor maintenance or incorrect installation of connectors
when assembling the Scooter after transportation in a car.
If your scooter should fail to operate, you will be assisted in diagnosis and locating the area
of the fault by observing the number of ashes emitted from the 'green' status light on your
control console.
22
To Next Page
Loading...
