FREEWHEELING YOUR SCOOTER
If for reasons of convenience, or you require to push your scooter for a short distance, the
drive system can be put into 'freewheel mode'. This will allow your scooter to roll freely.
1. Freewheel Procedure:
The freewheel device is a red lever located at the rear right hand side of your scooter.
To freewheel your scooter rst switch off the power switch located on the scooter’s control
console.
Pull up the disengage lever until a distinct click is felt. You can now push your scooter with
ease.
Please note, in this mode with the power switch in the off position, the braking safety system
is automatically activated when the scooter is pushed quicker than walking speed, this is an
automatic 'run away' safety checking system, it also reduces the risk of casual theft.
ELECTROMAGNETIC AND RADIO FREQUENCY INTERFENCE (EMI/RFI)
Electromagnetic and Radio Frequency Interference can come from mobile phone, radio
transmitters etc. In some cases, these waves can cause damage to control system. Your scooter
has an immunity to EMI, the higher the immunity level, the greater the protection against
EMI.
Your scooter has been tested and passed at the immunity level of 20 V/M.
Warning: Additional of accessories or components to your scooter can increase the
susceptibility to EMI. DO NOT modify scooter in any way not authorized.
1. Safety Check:
We recommend that you perform a safety check before each use to make certain your scooter
operates smoothly and safely.
SAFETY INSTRUCTIONS & WARNING
14
To Next Page
Loading...
