A Open HARDWARE BAG 3.
B Align upper CROSS BAR with
holes in CONSOLE MAST
.
C Insert 1 BOLT (E), 1 SPRING
WASHER (F) and 1 WASHER (G)
into each of the 4 holes of the
CROSS BAR
.
D Tighten all 4 BOLTS (E).
E Connect power plug to the
treadmill and connect the cord to
a power outlet. The on/off switch
is located next to the power
cord. Flip this switch to the 'on'
position, so that the switch is
lit. You will hear a beep and the
console will light up.
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
LIMITED
WARRANTY
9
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
To Next Page
Loading...
