Need help?Do you have a question about the FreeWave FGR-115RE and is the answer not in the manual?
General| Modulation | FHSS (Frequency Hopping Spread Spectrum) |
|---|---|
| Data Rate | 115.2 kbps |
| Operating Temperature | -40°C to +75°C |
| Frequency Range | 902-928 MHz |
| Receiver Sensitivity | -108 dBm |
| Interface | RS232 |
| Power Output | 1 Watt (30 dBm) |
| Input Voltage | 6 to 30 VDC |
Steps to establish a communication link between two FreeWave transceivers.
Configures the transceiver as a master in a point-to-point communication link.
Configures the transceiver as a slave in a point-to-point communication link.
Configures the transceiver as a master for multipoint communication.
Configures the transceiver as a slave for multipoint communication.
Configures the transceiver to act as either a slave or a repeater.
Configures the transceiver to extend the range of point-to-point links.
Enables a transceiver to be controlled via software commands.
Configures the transceiver as a repeater in a multipoint network.
Procedure to set the RS232 baud rate for the transceiver.
Instructions for adding, modifying, or deleting entries in the transceiver's call book.
Step-by-step guide for updating serial numbers and repeater information in the call book.
Detailed procedure for configuring call book entries for multiple repeaters.
Guidelines for setting up call books in multipoint network configurations.
Accessing and modifying key radio transmission settings.
To Next Page
