Need help?Do you have a question about the FreeWave FGRO9CSU and is the answer not in the manual?
General| Brand | FreeWave |
|---|---|
| Model | FGRO9CSU |
| Category | Transceiver |
| Language | English |
Guides users through initial setup for multipoint FreeWave systems.
Configures the transceiver's role (Master/Slave) in communication links.
Establishes the RS232 communication rate between the transceiver and connected devices.
Configures the transceiver as a master for multipoint networks.
Configures the transceiver as a slave in a multipoint network.
Explains the fundamental principles of multipoint network communication.
Configures the count of repeaters present in the multipoint network.
Sets the packet retransmission count for masters communicating with slaves.
Details setting the Master Packet Repeat parameter for repeaters.
Configures the RS232 baud rate for communication with connected instruments.
Configures lists of transceivers for secure and flexible communication.
Details the process for adding or changing serial numbers in the Call Book.
Allows modification of radio transmission parameters for optimal performance.
Modifies hopping patterns to minimize interference with other transceivers.
Designates the maximum size of data packets transmitted by the transceiver.
Designates the minimum size of data packets transmitted by the transceiver.
Configures the RF data rate for optimal throughput or link stability.
Enables or disables security to control which units can initiate calls to the slave.
Indicates the level of background noise and interference at the modem.
Shows the received signal level at the modem and any repeaters in the link.
Establishes a password to prevent unauthorized access to radio parameters.
Allows modification of the existing password for security.
Outlines the procedure to remove or deactivate the password feature.
To Next Page
