FreeWave Technologies Spread Spectrum Transceiver User Manual
900 MHz and 2.4 GHz
V5.0S
ix
Table of Contents
QUICK START..................................................................................................... 1
QUICK START ON A MULTIPOINT SYSTEM.................................................... 2
TUNING TRANSCEIVER PERFORMANCE .......................................................3
OPERATION MODE SELECTIONS.................................................................... 6
(0) POINT-TO-POINT MASTER...........................................................................6
(1) POINT-TO-POINT SLAVE.............................................................................. 6
(2) POINT-TO-MULTIPOINT MASTER.................................................................. 6
(3) POINT-TO-MULTIPOINT SLAVE.....................................................................6
(4) POINT-TO-POINT SLAVE/REPEATER ............................................................6
(5) POINT-TO-POINT REPEATER .......................................................................7
(6) POINT-TO-POINT SLAVE/MASTER SWITCHABLE ........................................... 7
(7) POINT-TO-MULTIPOINT REPEATER ............................................................10
(F) ETHERNET OPTIONS .................................................................................10
MULTIPOINT OPERATION............................................................................... 11
THEORY OF OPERATION................................................................................. 11
INSTALLING MULTIPOINT SYSTEMS ................................................................. 11
OVERLAPPING MULTIPOINT SYSTEMS .............................................................12
(0) NUMBER REPEATERS ...............................................................................12
(1) MASTER PACKET REPEAT.........................................................................12
MASTER PACKET REPEAT IN MULTIPOINT SYSTEMS WITH REPEATERS.............14
(2) MAX SLAVE RETRY...................................................................................15
(3) RETRY ODDS ........................................................................................... 15
(4) DTR CONNECT ........................................................................................ 15
(5) REPEATER FREQUENCY............................................................................ 15
(6) NETWORK ID........................................................................................... 16
(8) MULTIMASTER SYNCH..............................................................................16
(9) 1 PPS ENABLE/DELAY ............................................................................. 16
(A) SLAVE/REPEATER....................................................................................17
(B) DIAGNOSTICS .......................................................................................... 17
(C) SUBNET ID..............................................................................................17
(D) RADIO ID................................................................................................. 20
BAUD RATE SELECTIONS .............................................................................. 21
(1) SET BAUD RATE...................................................................................... 21
(2) DATA WORD LENGTH AND PARITY ............................................................ 22
(3) MODBUS RTU ......................................................................................... 22
RS232/485................................................................................................... 22
SETUP PORT ................................................................................................. 23
TURNOFF DELAY............................................................................................ 23
FLOW CONTROL ............................................................................................ 24
CALL BOOK SELECTIONS.............................................................................. 25
ENTERING OR MODIFYING NUMBERS IN THE CALL BOOK .................................. 26
PROGRAMMING THE CALL BOOK TO USE 3 OR 4 REPEATERS .......................... 27
PROGRAMMING THE CALL BOOK IN MULTIPOINT SYSTEMS .............................. 28
To Next Page
Loading...
