FreeWave Technologies Spread Spectrum Transceiver User Manual
900 MHz and 2.4 GHz
V5.0S
58
Other Settings
A number of parameters other those shown in the setup menu may be set on
FreeWave transceivers. The parameters below may be set with DOS based
software available by contacting FreeWave Technologies.
Baud Rate
The transceiver's RS232 baud rate may be set to 300, 600, or 900 baud.
Setup Timeout
When enabled this mode invokes a timeout feature for the Setup Menu. If the
transceiver goes into setup and does not receive a legitimate menu selection
within 3 to 5 seconds it will go back out of setup and into its previous mode.
To Next Page
Loading...
