freightliner Argosy COE - 42-10 Bendix E-6 Foot Control Valve Inspection and Lubrication; 42-11 Brake Inspection

Rotate the cartridge clockwise about one full
turn. Firmly tighten the cartridge.
6. Remove the chocks from the tires.
42–10 Bendix E–6 Foot Contol
Valve Inspection and
Lubrication
1. Remove the foot control valve from the vehicle.
See Section 42.03, Subject 110 of the
Century
Class Trucks Workshop Manual
for instructions.
2. Remove the roll pin from the brake pedal pivot
pin. See Fig. 9.
3. Remove the brake pedal pivot pin.
4. Remove the brake pedal.
5. Check the brake pedal mounting plate adapter
for signs of wear or cracks at the bosses (the
area from which the pivot pin was removed). Re-
place it if necessary.
6. Check the brake pedal rollers for signs of wear
or cracks. Replace them if necessary.
7. If the rollers are replaced, replace the roller pin,
then install a new cotter pin and bend it 90 de-
grees, and apply torque seal (OPG F900 White)
to the cotter pin.
f420012a
10/20/93
1
2
3
4
5
6
7
1. Brake Chamber
2. Clevis
3. Actuator Rod
4. Boot
5. Pressure-Relief Capscrew, Gasket, Pawl Spring,
and Pawl
6. Manual Adjusting Nut
7. Grease Fitting (or plug)
Fig. 7, Meritor Automatic Slack Adjuster
04/16/98
f421910
1
2
3
1. Desiccant Cartridge
2. Cartridge Sealing Ring
3. Threaded Base Post
Fig. 8, Desiccant Cartridge Replacement
09/10/2004
f430405
1
2
3
4
6
7
8
5
1. Foot Control Valve,
E-6
2. Mounting Plate
3. Nut and Washer
4. Pivot Pin
5. Roll Pin
6. Roller
7. Roller Pin
8. Pedal
Fig. 9, Brake Pedal and Valve Assembly
Brakes 42
Century Class Trucks Maintenance Manual, April 2005 42/7