Maintenance Operation Sets
Maint.
Operation
Number
Operation Description
Service Schedules
I, II, and III
Service Schedule
IV
IM M1 M2 M3 IM M1 M2 M3
00–04 Lubrication and Fluid Level Check •••• ••
01–01 Engine Noise Panel Inspection (noise emission control) • • • •
01–02 Engine Drive Belt Inspection • • • •
01–03 Engine Mount Inspection (noise emission control)
*
01–04 Engine-Support Fasteners Check (noise emission control) • • • •
09–01 Air Cleaner Element Inspection and Replacement • • • •
15–01 Alternator, Battery, and Starter Check • • • •
20–01 Pressure Relief Cap Check • • • •
20–02 Radiator Pressure-Flushing and Coolant Change • •
20–03 Fan Clutch Check (noise emission control) ••••••••
25–01 Eaton Fuller Clutch Release Bearing Lubrication •••• ••
25–02 Clutch Release Cross-Shaft Lubrication • • • •
25–03 Sleeve Assembly Bronze Bushing Lubrication • • • •
25–04 Meritor Clutch Release Bearing Lubrication • •
26–01 Manual Transmission Fluid Change, and Magnetic Plug Cleaning
(synthetic lubricant)
••
26–02 Allison Transmission Fluid and Filter Change • •
26–03 Manual Transmission Air Filter/Regulator Check, Cleaning, or
Replacement
•• ••
26–04 Transmission Fluid Level Inspection • • • •
31–01 Fifth Wheel Inspection ••••••••
31–02 Fifth Wheel Lubrication ••••••••
31–03 Frame Fastener Torque Check • •
32–01 Suspension Inspection • • • •
32–02 Suspension Lubrication ••••
32–03 Suspension U-Bolt Torque Check • • • • • •
33–01 Knuckle Pin Lubrication, Meritor Axles • • • •
33–02 Tie Rod Inspection • • • •
33–03 Tie Rod Lubrication, Meritor Axles • • • •
33–04 All-Axle Alignment Check • •
33–05 Knuckle Pin Lubrication, Dana Spicer Axles ••••
33–06 Tie Rod Lubrication, Dana Spicer Axles ••••
33–07 Basic Inspection, Meritor Unitized Wheel Ends
†
•• ••
33–08 End-Play Check, Meritor Unitized Wheel Ends
‡
•• ••
General Information 00
Maintenance Operation Sets Table: 00–09
Century Class Trucks Maintenance Manual, January 2007 00/15
To Next Page
Loading...
