Maintenance Operation 00–04, Lubrication and Fluid
Level Check Operation Table 8 summarizes all op-
erations that must be performed to complete the Lu-
brication and Fluid Level Check operation 00–04
called for as an M1 maintenance interval for Service
Schedule I, II, and III vehicles, and as an M2 mainte-
nance interval for Service Schedule IV vehicles.
Maintenance operation numbers given in the table
are reference numbers used to help you find detailed
instructions in the manual on the lubrication or fluid
check.
Maintenance Operation 00–04
Lubrication and Fluid Level Check for Service Schedules I, II, III, and IV
Maint.
Operation
Number
Operation Description
Service
Schedules
I, II, and III
(at M1)
Service
Schedule IV
(at M2)
Check
25–01 Eaton Fuller Clutch Release Bearing Lubrication •
25–02 Clutch Release Cross-Shaft Lubrication •
25–03 Sleeve Assembly Bronze Bushing Lubrication •
26–04 Transmission Fluid Level Inspection •
31–02 Fifth Wheel Lubrication • •
32–02 Suspension Lubrication •
33–01 Knuckle Pin Lubrication, Meritor Axles •
33–03 Tie Rod Lubrication, Meritor Axles •
33–05 Knuckle Pin Lubrication, Dana Spicer Axles •
33–06 Tie Rod Lubrication, Dana Spicer Axles •
35–02 Axle Breather and Axle Lubricant Level Inspection •
41–02 Driveline Lubrication • •
42–05 Dana Spicer Camshaft Bracket Lubrication •
42–06 Dana Spicer, Haldex, and Gunite Slack Adjuster
Lubrication
•
46–03 Power Steering Fluid Level Inspection •
46–04 Power Steering Gear Lubrication •
46–05 Drag Link Lubrication •
60–02 Cab Tilt Pump Reservoir Fluid Level and System Check • •
72–01 Door Seal, Door Latch, and Door Hinge Lubrication •
Table 8, Maintenance Operation 00-04, Lubrication and Fluid Level Check for Service Schedules I, II, III, and IV
General Information00
Lubrication and Fluid Level Check: 00–04
Century Class Trucks Maintenance Manual, January 200700/8
To Next Page
Loading...
