IMPORTANT: After performing all operations in this
table, perform all daily and weekly maintenance op-
erations listed in the "Pretrip Inspection and Daily
Maintenance" chapter of the
Business Class Trucks
Driver’s Manual
. Also, perform all M1 and M2 Mainte-
nance Interval Operations at the M3 Maintenance
Interval.
NOTE: Numbers in this table are maintenance opera-
tion reference numbers matching those in the text of
this manual. The M3 Maintenance consists of all M1
and M2 Interval Operations plus the other operations
listed below.
M3 Maintenance Interval Operations
Maint.
Oper. No.
M3 Maintenance Interval Operations
00–10 Perform All M1 Operations
00–11 Perform All M2 Operations
01–02 Engine Drive Belt Inspection
25–02 Clutch (Pull-Type) Inspecting and Adjusting
26–05 Allison Transmission Fluid and Filter Changing
26–08 Aisin Transmission Fluid and Filter Changing and Magnetic Plug Cleaning
31–04 Holland Fifth Wheel Sliding Mechanism Inspecting
32–03 U-Bolt Torque Checking
33–06 All-Wheel-Drive Front Axle Oil Changing
35–05 Two-Speed-Axle Shift Unit Oil Changing
40–01 Wheel Nut Checking
42–15 Air Dryer Checking, Bendix AD–9
47–01 Fuel Tank Draining and Vent Checking
54–01 Electrical System Checking
General Information 00
M3 Maintenance Interval Operations Table: 00–12
Business Class Trucks Maintenance Manual, February 2004 00/21
To Next Page
Loading...
