EasyManua.ls Logo

Fri-Jado TDR 8 P eco - User Manual

Default Icon
104 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
WWW.FRIJADO.COM
Service Manual TDR5/8 P TDW5/8 P form 9123911 rev. 10/2014
SERVICE MANUAL
TDR P
eco
- ROTISSERIE OVEN MODELS
TDW - WARMER MODELS
- NOTICE -
This manual is prepared for the use of trained Service Technicians
and should not be used by those not properly qualified. If you
have attended a training for this product, you may be qualified to
perform all the procedures in this manual.
This manual is not intended to be all encompassing. If you have
not attended a training for this product, you should read, in its
entirety, the repair procedure you wish to perform to determine
if you have the necessary tools, instruments and skills required to
perform the procedure. Procedures for which you do not have the
necessary tools, instruments and skills should be performed by a
trained technician.
Reproduction or other use of this Manual, without the express
written consent of Fri-Jado, is prohibited.
MODELS
TDR 5 P
eco
TDR 8 P
eco
TDW 5 P
TDW 8 P
Model TDR 5 P
eco
Model TDR 8 P
eco

Table of Contents

Other manuals for Fri-Jado TDR 8 P eco

Preview: Installation Manual
Installation Manual32 pages

Questions and Answers

  • T
    Tiffany McguireAug 17, 2025
    Why does the oven temperature differs from temperature setting in my Fri-Jado Kitchen Appliances?
    • C
      Cathy ArnoldAug 18, 2025
      If the Fri-Jado Kitchen Appliance oven temperature differs from the temperature setting, it could be due to several reasons: * Incorrect line voltage. * Malfunction of the safety thermostat. * Inoperative blower motor (check turning direction). * Inoperative electronic control. * Malfunction of the PT 1000 sensor. * The PT 1000 sensor is not in the right place. * Dirty fanguard or fanblade.
  • K
    Katie HuangAug 20, 2025
    Why Fri-Jado Kitchen Appliances oven temperature does not reach desired temperature?
    • J
      Justin BlakeAug 20, 2025
      If the Fri-Jado Kitchen Appliance oven temperature isn't reaching the desired level, it could be caused by: * A malfunctioning safety thermostat. * An inoperative contactor. * A malfunctioning PT 1000 sensor or its incorrect placement. * An inoperative electronic control. * Inoperative heater(s). * Incorrect line voltage.
  • A
    amandaewingAug 22, 2025
    Why does the main fuse or breaker blows on my Fri-Jado Kitchen Appliances?
    • D
      dandersonAug 22, 2025
      If the main fuse or breaker blows in your Fri-Jado Kitchen Appliance, it could be due to: * Incorrect wiring. * A shorted heating element, drive motor, blower, or contactor. * Shorted wiring.
  • R
    Ryan Smith MDAug 26, 2025
    Why infrared Halogen lamps do not work in Fri-Jado Kitchen Appliances?
    • J
      Jason JimenezAug 26, 2025
      If the infrared Halogen lamps in your Fri-Jado Kitchen Appliance do not work, the possible causes are: * Contactor inoperative. * Broken lamp(s). * Broken lamp holder. * Loose wiring.
  • M
    Matthew BatesAug 28, 2025
    What causes the drive motor not to run during cooking cycle in Fri-Jado Kitchen Appliances?
    • T
      Tina CooperAug 28, 2025
      If the drive motor in your Fri-Jado Kitchen Appliance does not run during the cooking cycle, it could be due to: * An inoperative main fuse on L1. * Capacitor malfunction. * Motor malfunction. * Door switch malfunction. * Power and I/O board malfunction (check relay X12). * Loose wiring.
  • K
    kmccormickAug 30, 2025
    Why all heating elements are out in my Fri-Jado Kitchen Appliances?
    • C
      Cynthia MendozaAug 30, 2025
      If all heating elements are out, but the halogen lamps and blower operate while the oven cavity is below the set temperature in your Fri-Jado Kitchen Appliance, it could be due to: * Malfunction of the safety thermostat. * Inoperative contactor. * Power and I/O board malfunction. * Loose wiring.
  • T
    Timothy MooreSep 1, 2025
    Why blower motor does not run in Fri-Jado Kitchen Appliances?
    • J
      Jordan CervantesSep 1, 2025
      If the blower motor in your Fri-Jado Kitchen Appliance does not run, consider the following possible causes: * Capacitor malfunction. * Motor inoperative. * Power and I/O board malfunction (check relay X6). * Loose wiring.
  • T
    Traci CabreraSep 4, 2025
    Why does drive motor stops and runs again after a certain period in Fri-Jado Kitchen Appliances?
    • B
      Brittany CabreraSep 4, 2025
      If the drive motor in your Fri-Jado Kitchen Appliance stops and runs again after a certain period, it is likely due to thermal protection being activated at 105°C. The motor will restart once the temperature drops below 105°C.
  • J
    Joanna HumphreySep 7, 2025
    Why does blower motor stops and runs again after a certain period in Fri-Jado Kitchen Appliances?
    • H
      hensonamySep 7, 2025
      If the blower motor in your Fri-Jado Kitchen Appliance stops and runs again after a certain period, it's because thermal protection has been activated at 140°C. It will resume running once the temperature falls below 140°C.
  • M
    mlaneSep 9, 2025
    Why all beep functions do not function anymore in Fri-Jado Kitchen Appliances?
    • A
      Adam BlackSep 9, 2025
      If all beep functions do not function anymore on your Fri-Jado Kitchen Appliance, it could be due to: * Obsolete software (older than V1.03.06). Load the latest software. If no software is available unplug the unit for 5 seconds and plug in again. Now the beep signal will work again for 49 days. * All sounds in the parameter list are disabled (switched off).

Summary

Service Manual Introduction

Product Models and Notices

Lists product models and provides important usage notices for the manual.

Technical Specifications

General and Detailed Technical Data

Covers product types, sizes, and detailed specifications including power, fuses, weight, and dimensions.

Programming and Operation Guide

Operating Panel and Basic Operation

Explains operating panel functions, keys, display, and step-by-step operation.

Advanced Operation and Settings

Covers operation options, manager menu functions, and parameter settings.

Parameter Management

Parameter Listing and Adaptation

Explains, lists, and guides on adapting parameters and loading software for P-control systems.

Maintenance and Repair Procedures

TDR Series Parts Replacement

Detailed instructions for removing and replacing components in TDR rotisserie ovens.

TDW Series Parts Replacement

Detailed instructions for removing and replacing components in TDW warming cabinets.

Troubleshooting and Diagnostics

Electrical Tests and Error Codes

Covers electrical tests, component checks, and explanations for error codes.

General Troubleshooting Guide

Lists common symptoms, causes, and troubleshooting steps for TDR and TDW units.

Visual Parts Identification

TDR Series Exploded Views and Parts

Visual exploded views and part lists for TDR 5 P and TDR 8 P models.

TDW Series Exploded Views and Parts

Visual exploded views and part lists for TDW 5 P and TDW 8 P models.

Electrical Diagrams and Schematics

TDR Series Electrical Diagrams

Circuit and wiring diagrams for TDR 5 and 8 P models, including version variations.

TDW Series Electrical Diagrams

Circuit and wiring diagrams for TDW 5 and 8 models, showing connections and configurations.

Fri-Jado TDR 8 P eco Specifications

General IconGeneral
ModelTDR 8 P eco
ControlDigital
TimerYes
Power Supply3N~ 400V/50Hz
Safety FeaturesOverheat protection

Related product manuals