To Next PageTo Next Page
Need help?Do you have a question about the Frick TDSH 193S and is the answer not in the manual?
General| Model | TDSH 193S |
|---|---|
| Manufacturer | Frick |
| Type | Screw Compressor |
| Capacity | 193 TR |
| Motor Power | 150 hp |
| Voltage | 460 V |
| Refrigerant | R717 (Ammonia) |
Explains the functions of the lubrication system for bearings, seals, and cooling.
Outlines requirements for the oil system, including selection, pressure, and cleanliness.
Specifies required oil pressure levels for proper compressor function.
Crucial warning about not mixing oils and guidelines for oil selection.
Emphasizes the importance of proper coupling alignment for component life.
Procedures for performing hot alignment after the unit has reached operating temperature.
Steps to replace and adjust the slide valve position potentiometer.
Steps to replace and adjust the volumizer potentiometer for Vi control.
Describes the hydraulic system for moving the slide valve and slide stop.
Provides logical step-by-step instructions for proper start-up and operation.
Key considerations and procedures before and during the initial start-up phase.
Step-by-step guide for performing the initial start-up of the compressor unit.
Crucial safety precautions to take before performing any maintenance.
Provides an organized approach to defining problems and making corrections.
Four logical steps to effectively analyze and correct operational problems.
Lists symptoms and probable causes/corrections for TDS_ compressor issues.
Identifies symptoms and probable causes/corrections for hydraulic system problems.
Lists symptoms and probable causes/corrections for oil pump and system issues.
Essential checks to be completed before arrival of the service supervisor.
