Warning!
If the LED light bulb is damaged, DO NOT CHANG IT BY THE USER!
Changing the LED light bulb carry out by inexperienced persons may cause injury or
serious malfunctioning.
It must be replaced by a qualified persons in order to avoid a hazard. Contact your local
Service Force Center for help.
Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or
the circuit breaker.
LED light bulb data: 220-240 V ,
To switch off the appliance, set the temperature regulator to position “0”.
Unplug the mains plug.
Press the bulb in the center with finger.
Take out the lampshade with “1” type screwdriver, change the bulb, and then replace
the lampshade..
Put the refrigerator back into operation.
Changing the light bulb
LED Bulb(inside)
Lampshade
Thermostat knob
19
Noises during Operation
The following noises are characteristic of refrigeration appliances:
Clicks Clicks
Whenever the compressor switches on or off, a click can be heard.
Humming
As soon as the compressor is in operation, you can hear it humming.
Bubbling
When refrigerant flows into thin tubes, you can hear bubbling or splashing noises.
Splashing
Even after the compressor has been switched off, this noise can be heard for a short
time.
To Next Page
Loading...
