Description of the appliance
The side at which the door opens can be changed from the right side (as supplied) to
the left side, if the installation site requires.
Tools you will need
1、8mm socket driver
2、cross-shaped screwdriver
Reversing the door
3、Putty knife or thin-blade screwdriver
Before you start lay the refrigerator on its back in or der to gain access to the base,you
should rest it on soft foam packaging or similar material to avoid damaging the cooling
pipes at the rear of the refrigerator.
1. Stand the refrigerator, use a flat b laded screw driver to remove t h e 4 screw
covers at the rear of the refrigerator lid.
7
1
2
3
4
5
6
7
8
9
10
11
2.Glass Shelf
3.Crisper Cover
4.Crisper
5.Upper Drawer in freezer
6.Lower Drawer in freezer
7.Upper Door shelf
8.Water Tank
9.Small Shelf
10.Mini Shelf
11.Lower Door shelf
1.LED Bulb & mperature Regulator Te
View of the appliance
To Next Page
Loading...
