24
Problem: Possible cause Solution
Heavy build-up
of frost, possibly
also on the door
seal.
• Door seal is not air-tight
(possibly after reversing the
door) .
• Carefully warm the
leaking sections of the
door seal with a hair
dryer (on a cool setting).
At the same time, shape
the warmed door seal
by hand so that it sits
correctly.
Unusual noises.
• Appliance is not level. • Readjust the feet.
• The appliance is touching the
wall or other objects.
• Move the appliance
slightly.
• A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
• If necessary, carefully
bend the component out
of the way.
The compressor
dose not start
immediately
after changing
the temperature
setting.
• This is normal, no error has
occurred.
• The compressor starts
after a period of time.
Water on the
floor or storage
shelves.
• Water drain hole is blocked.
• Refer the “Cleaning and
Care” section.
Changing the light bulb
Warning! If the light bulb is damaged, DO NOT CHANG IT BY THE USER!
Changing the light bulb carry out by inexperienced person may cause injury or
serious malfunctioning. It must be replaced by a qualified persons in order to
avoid a hazard. Contact your local Service Force. Center for help.
EN
To Next Page
Loading...
