Operation FR35 DC, FR35 AC/DC
30
➤ Leave the cover open.
➤ Wipe off the defrosted water.
6.10 Replacing the plug fuse (12/24 V)
➤ Pull the adapter sleeve (fig. 5 4, page 3) off of the plug.
➤ Unscrew the screw (fig. 5 5, page 3) out of the upper half of
the housing (fig. 5 1, page 3).
➤ Carefully raise the upper half of the housing from the lower
(fig. 5 6, page 3) half.
➤ Take out the contact pin (fig. 5 3, page 3).
➤ Replace the defective fuse (fig. 5 2, page 3) with a new one
that has the same rating (8A 32V).
➤ Re-assemble the plug in the reverse order.
6.11 Replacing the light bulb
➤ Press the switch pin (fig. 6 2, page 3) downwards so that the
transparent part (fig. 6 1, page 3) of the lamp can be removed
at the front.
➤ Replace the light bulb.
I
➤ Press the transparent part of the lamp back into the housing.
NOTE
The LEDs in the light bulb must be aligned with the transparent
part of the lamp.
To Next Page
Loading...