Friedman SS-100 - REAR PANEL CONNECTIONS AND CONTROLS; Foot Switch and FX Loop Jacks; Line Out and Speaker Outputs; Impedance Selector and Fuses


REARPANEL


FOOTSWITCHJACK:Thisiswhereyoupluginthesuppliedtwobuttonfootswitch(clean/dirty/boost)

FXLOOPSWITCH:ThiswillengagetheseriesFXloop.ThefrontGainchannelVolumecontrolbecomes
theSENDlevel(MUSTBESETAT5‐6forUNITYGAIN)foryoureffectsandtheRETURNLEVELCONTROL
becomesyouramp’sMASTERVOLUME.Adjustthecleanchanneltomatchlevelstoyourgainchannel
volume.

RETURNJACK:ThisiswhereyouplugtheOUTofyourEffect(s).Useahighqualityshieldedguitarcable.

SENDJACK:ThisiswhereyouplugtheINPUTofyourEffect(s).Useahighqualityshieldedguitarcable.

RETURNLEVELCONTROL:ThisbecomesyourMASTERVOLUMEwhentheFXloopisengaged.

LINEOUTCONTROL:Thiscontrolsthesignallevelofthelineout.

LINEOUTJACK:Attachashieldedguitarcabletosendalinelevelsignalouttoanexternaldevice.This
isnotspeakercompensated.OnemightusethelineouttoconnecttoanFXunit,powerampand
speaker(s)tocreateaW/D/WorW/Drig.

SPEAKEROUTJACKS(2):PluginSpeakercab(s)here.UseSPEAKERCABLESONLY

IMPEDANCESELECTORSWITCH:Choosethecorrectimpedanceforyourcab(s).4/8/16ohms

MAINFUSE:Replacewiththesametypeoffuseindicatedonthebackpanel.Ifthisfuseblowsitismost
likelytheresultofabadtube.Constantblowingofthisfuse(evenwhenusingnewtubes)isan
indicationthatsomethingcouldbeseriouslywrongwithyouramp.STOP
andcallussowemayhelpyou
diagnose.

HTFUSE:Onlyreplacewithsametypeoffuseindicatedonthebackpanel.Ifthisblows,don’tfreakout
toomuch.It’smostlikelyabadpowertube.Werecommendyoucarryafewsparefusesandaspareset
oftubeswhengigging.

MAINSINPUT:PlugthesuppliedIECpowercordhereandintoa115vwalloutlettopowerthebeast.

FXLOOPINSTRUCTIONS:YoumustsettheGainChannelVolumeto5‐6toprovideunitygainforyourFX
units.ItisnowtheSENDcontrol.
TheRETURNLevelControlisnowyourMASTERVOLUMEfortheamp.
Adjustthecleanchannelvolumetomatchyourgainchannel.Thisruleapplieswhentheloopisengaged.




