To Next PageTo Next Page
Need help?Do you have a question about the Friedman BE100 and is the answer not in the manual?
General| Type | Tube Amplifier |
|---|---|
| Power | 100 Watts |
| Preamp Tubes | 4 x 12AX7 |
| Power Tubes | 4 x EL34 |
| Master Volume | Yes |
| Effects Loop | Yes |
| Weight | 42 lbs |
| EQ | 3-Band (Bass, Middle, Treble) |
| Footswitch | Included |
| Speaker Outputs | 2 x 1/4" |
| Footswitchable | Channels, Effects Loop |
| Inputs | 1 x 1/4" |
Manages plug-in insertion for latency during recording in Console software.
Controls the overall power state of the plug-in, allowing for bypass comparison.
Adjusts the amount of distortion from the 12AX7 preamp section.
Controls the volume level for the clean channel.
Adjusts the volume for the BE/HBE channels; higher settings increase loudness.
Bass, Middle, Treble, and Presence controls for the distortion channels.
Bass and Treble controls specifically for the clean channel.
Includes FAT, C45, SAT, and VOICE switches for tonal customization.
A three-position switch affecting the Clean Channel's brightness.
Switches between Clean, BE, and HBE channels for different amp tones.
Manages input signal noise, with controls for Threshold, Range, and On/Off.
Includes TIGHT (low-cut) and SMOOTH (high-cut) filters, switchable PRE/POST.
Selects speaker and cabinet setups from a library of customized recording chains.
Vintage-style stomp box delay with modern features like mix and BPM sync.
Adjusts input signal level to drive the preamp harder or softer.
Simulates a power soak to reduce volume while retaining power amp clipping.
Controls bypass for the preamp and power amp sections for flexible routing.
Manages undo/redo, A/B/C/D settings, copy/paste, and FX Rack view.
Offers a wide variety of presets, many optimized for classic guitars.
Guidance on adjusting DRIVE, TONE STACK, and REC CHAINS for custom sounds.
