Friedrich EMRT1 - Testing the Thermostat

16
Testing the thermostat
Following the thermostat conguration, test if the thermostat is controlling the PTAC
unit.
➤ Press the “Power” button to turn the thermostat ON;
➤ Press the “Up” and “Down” buttons to change the temperature set point
above and below the current room temperature to test if the thermostat
initiates heating and cooling - the PTAC unit should turn heating and air
conditioning on and off.
➤ Change the fan speed by touching the “Fan” button to test if the thermostat
is controlling the fan speed.
Thermostat Conguration