Need help?Do you have a question about the Friedrich EMWRT2 and is the answer not in the manual?
General| Brand | Friedrich |
|---|---|
| Model | EMWRT2 |
| Category | Thermostat |
| Language | English |
Procedure to link the thermostat and control card for proper operation.
Steps to install the wireless control card and wiring details.
Instructions for physically attaching the thermostat to the wall.
Guide for setting the current time on the thermostat in 24h format.
Instructions for inputting the room number for remote management.
Setting the compressor type (No Compressor, Heat Pump, Air Conditioner).
Setting the electric heat option (No Electric Heat, Electric Heat).
Setting the reversing valve for heating or cooling mode.
Selecting pre-defined energy saving presets or custom settings.
Verifying thermostat control over HVAC unit and fan speed.
Procedure to enter custom energy saving settings via button press.
Navigation instructions for the thermostat settings screens.
Setting fan operation mode (Manual or Automatic).
Setting temperature differential for 1st stage heating.
Setting temperature difference for 2nd stage heating initiation.
Setting temperature differential for 1st stage cooling.
Minimum time for occupancy detection to enter guest occupancy mode.
Minimum time for occupancy to be considered during night occupancy.
Setting duration for 1st stage heating before 2nd stage activation.
Setting the start time for the 'Night Occupancy' period.
Setting the end time for the 'Night Occupancy' period.
Maximum time for HVAC to reach recovery temperature.
Target room temperature for heating recovery.
Time delay before heat setback is initiated after room becomes unoccupied.
Minimum temperature in setback mode for heating.
Time delay before cool setback is initiated after room becomes unoccupied.
Maximum temperature in setback mode for cooling.
Target room temperature for cooling recovery.
Minimum temperature a guest can select.
Maximum temperature a guest can select.
Setting temperature control mode (Manual or Automatic).
Difference between set points for automatic heating/cooling changeover.
Controls behavior of setback and auto-restore when occupancy changes.
Enables automatic humidity control based on set conditions.
Allows calibration of the thermostat's temperature display.
Instructions for replacing the thermostat's batteries.
List and explanation of error codes displayed on the thermostat.
Troubleshooting steps for when the thermostat fails to control the HVAC unit.
To Next Page
