Installation Instructions
MOUNT THE MICROWAVE
OVEN (cont.)
[]Insert 2 self-aligning screws
through outer top cabinet
holes. Turn two full turns on
each screw.
I
[] Tighten center
screw completely.
[] Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
_ Install grease filters. See the Owner's Manual
packed with the microwave.
INSTALLING THE
CHARCOAL FILTER
NOTE: The charcoal filter is factory installed in
recirculating models. Follow these steps to replace a
filter or to install a filter after converting a vented
model to recirculating operation.
[]Remove screws on fi'ont of grille using a
#1 Phillips screwdriver.
_Open the door.
[]Remove the grille.
Pull the grille straight off.
Charcoal
Filter
[] hrstall the charcoal filter. When properly installed,
the wire mesh of the filter should be visible from
the fl'ont.
[Replace the grille and the screws.
[]Close the door.
Insertmesh-sideup
22
To Next Page
Loading...
