TROUBLE SHOOTING
The indicator is not on.
The compressor doses not
start.
The plug isn’t connected to
the socket really.
Connect the socket with
power.
The indicator is on ,but the
com- pressor doesn’t work
and buzzes only
The power voltage is＜98V.
Put a power-regulater more
than
1000W power together.
The compressor stops a
minute after start, and
restart after a few minutes,
and so repeatedly.
The power voltage is＞
132V.
The compressor works
normally, but the
temperature in the cabinet
lowers too slowly.
The door is opened too
frequently.
The food in the cabinet is
too much, and placed
improperly.
Place foods properly
keep place between
them for ventilation of
cold air.
The frost film is too thick.
Take out foods and defrost.
The surface of the
condenser is too dirty.
Stop and clean the
condenser.
The freezer is placed
unstably.
The fixing of the freezer is
loose.
there’s contact between
pipes.
The following are not faults:
When the freezer is working or after stopping for a while, the refrigerant in the pipes is
cycling and gives out＂running water＂sounds.
The surface temperature of the compressor may be up 158°F~176°F when it is
working.
The back side of step freezer gives out heat.
In rainy season, the outer surface of the cabinet may have dew, which makes no
defects on normal use. Just dry it with a piece of cloth.
The protective film on the inner tank is to avoid damage during production purpose.
Don’t worry about peeling it off. It’s okay to tear it off when you use it.
To Next Page
Loading...
