5
2009 Electrolux Home Products, Inc. All rights reserved.
1. To shut the unit down, rotate the humidity knob to the OFF position.
Removing Collected Water
1. Emptying the Bucket:
a. When the bucket is full the unit will shut down and the BUCKET FULL indicator light will illuminate.
b. Do not move the unit at this point otherwise water may spill on the floor.
c. Press sides of bucket gently to unclip the bucket from the unit.
d. Remove the bucket as shown in the photographs below and empty the bucket.
Operating Instructions
Operating Instructions
(continued)
e. Replace the empty bucket back into the unit and once seated correctly the unit will start
up again.
f. You should hear a click when the bucket is in the correct position
If the bucket full light does not extinguish, check that the float is correctly snapped in place
as indicated by the diagram.
Discard water from bucket. Water is not potable and cannot be used for drinking.
WARNING
While the power indicator lit, rotate the humidity knob to the OFF position or removing the plug will extinguish this light.
NOTE:
To Next Page
Loading...
