Reattaching the door
1
Holding the door in both hands, squarely insert
the "T" post on the back of the hinge into the "T"
slot on the front panel and lower it to align the
mounting holes.
"T" POST ON
DOOR HINGE
"T" SLOT IN
FRONT PANEL
2
While supporting the door, install the upper pan
head screw first and then the lower one.
Close the door and test operation of hinge, strike
and latch.
Correctly installed hinge screws will press hinge flush
to front panel. Any gap between hinge and front panel
will cause misalignment of strike to latch.
To Next Page
Loading...
Need help?
General
