7
36” FULL GAS RANGE INSTALLATION INSTRUCTIONS
2. Secure the handle by tightening the screws
underneath both its ends. Use the provided 3/32”
hex Allen key.
Island installation
If the appliance is installed as an island:
1. Unscrew the screws indicated.
2. Remove the spacers (A).
3. Insert the screws that were previously removed
into their seats.
Keep a minimum clearance of 5 7/8" (150 mm)
between the appliance and the other furnishings or
decorative elements according to the diagram
below.
Keep a minimum clearance of 20” (508 mm)
between the appliance and any flammable furniture
elements.
The side cabinet depth (clearance A) must match
the front edge of the range side panel:
Unpacking, moving and
positioning the range
• It is recommended that the front kick panel, the
backguard and oven racks be removed to facili-
tate handling. This will reduce the weight for mov-
ing.
• When positioning the appliance during installa-
tion, do not use the door handle to lift or move the
appliance.
• Wear gloves to avoid cutting fingers on sharp
edges during installation.
CAUTION This unit is designed as a cooking
appliance. For safety reasons, never use it for
warming the room or as a space heater.
To Next Page
Loading...
