Fritz! 1750E - Slow Wireless AC;N Throughput; Cannot Access Network Devices

30
Throughput too Slow for Wireless AC or Wireless N
Test a different radio channel. If possible, set automatic radio
channel selection in the wireless access point. Your
FRITZ!WLAN Repeater then will use the same channel auto-
matically.
8.5 Throughput too Slow for Wireless AC or Wireless N
A wireless device (for instance, a computer) connected with
the FRITZ!WLAN Repeater should use the 802.11ac
(Wireless AC) or 802.11n (Wireless N) standard for high data
transmission speeds. The throughput achieved by this de-
vice, however, is too low for Wireless AC or Wireless N.
In the FRITZ!WLAN Repeater or in the wireless access point an
encryption method other than WPA2 has been configured.
The high transmission speeds of Wireless AC and Wireless N
can be used only with the encryption method WPA2. Enable
WPA2 in the wireless access point and in the
FRITZ!WLAN Repeater.
You can also use Wireless AC and Wireless N in non-encrypt-
ed (open) wireless networks. However, an open wireless radio
network is a security risk. Therefore we strongly recommend
encrypting all wireless networks!
8.6 Cannot Access Devices in the Network
No other devices in the network can be accessed.
A firewall is running on the devices.
Configure the firewall to allow access to the network.
The devices are not configured to receive their IP addresses
automatically.
Cause
Help
Cause
Help
Cause
Help