8
Button and LEDs
LEDs
LED Condition Meaning
Signal
strength
flashing
• Searching for wireless access point
• No connection with the wireless
access point
on The more LEDs are lit up, the stronger the
connection with the wireless access point
In the “LAN Bridge” mode: signal strength
of the connection with the first registered
wireless LAN device
Power flashing
• FRITZ!WLAN Repeater starts
• Updating the firmware of the
FRITZ!WLAN Repeater
on FRITZ!WLAN Repeater is ready for opera-
tion
WLAN flashing
• FRITZ!WLAN Repeater adopts wireless
LAN settings
• Switching wireless radio network on or
off
• Performing WPS
flashing
rapidly
WPS aborted. More than two WLAN devic-
es are performing WPS at the same time.
Restart WPS.
on Wireless LAN is enabled
LAN on A network connection has been estab-
lished to a connected network device
All flashing Loading factory settings
To Next Page
Loading...
