When the LED on the FRITZIRepeater lights up permanently, the Wi-Fi connection has been
established.
If the LED starts flashing slowly green again, the connection was W not established. Repeat the connection instructions starting from step 3.
5. Insert the FRITZ! Repeater into an outlet located about halfway between the FRITZ! Box and the wireless devices to be added to the Wi-Fi network. The
FRITZ! Repeater and your FRITZIBox connect once more. As soon as the connection has been established, the LED lights up. The FRITZ! Repeater 600
is ready for operation.
LED lights up green the FRITZ! The repeater has a good Wi-Fi connection and is ready for operation.
LED lights up orange the FRITZIRepeater has a weak wireless LAN connection. Plug the FRITZ!Repeater into an outlet closer to your FRITZ!Box.
LED flashing continuously orange cannot connect via Wi-Fi. Plug the FRITZIRepeater into an outlet closer to your FRITZIBox.
With the FRITZIApp WLAN, you can determine the optimum position for your FRITZIRepeater in the home network of your FRITZ! Box.
Connect the FRITZ! Repeater 600 to the Wireless Router using the Wizard
If your wireless router does not support setup at the touch of a button (WPS), use the wizard to connect the FRITZ! Repeater with the wireless router.
1. Establishing a Connection to the Computer
1. Plug the FRITZ!Repeater into an outlet near your wireless router. The FRITZ! Repeater starts operation.
2. Wait until the LED starts slowly flashing green.
3. Select the Wi-Fi network of your FRITZIRepeater on the computer, and start the connection process.
4. Enter the network key of the FRITZIRepeater. The preconfigured unique network key is printed on the back of this guide and on the back of the device
housing.
The computer establishes a connection to the FRITZIRepeater.
2. Run the Wizard
1. Open the web browser on your computer and enter http://fritz. repeater in the address bar.
2. The configuration wizard appears and guides you through the setup of the Wi-Fi connection between the FRITZIRepeater and your wireless router.
3. Insert the FRITZ! Repeater into an outlet located about halfway between the wireless router and the wireless devices to be added to the Wi-Fi The FRITZ!
Repeater and your wireless router connect once more.
LED lights up green: the FRITZIRepeater has a good Wi-Fi connection and is ready for operation.
To Next Page
Loading...
