EasyManua.ls Logo

Frog Pool Frog XL Pro - Using FROG BAM; Preparing FROG BAM; Removing FROG BAM

Frog Pool Frog XL Pro
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
7.
8.
9.
Using FROG BAM® for an Algae Protection Guarantee
If you are not using FROG BAM, proceed to Step 15.
See FROG BAM® product labeling for complete directions
for use (EPA Reg. No. 53735-9).
For a preventive dose add:
• One FROG BAM® for pools up to 15,000 gallons.
• Two FROG BAM® for pools between 15,000 and 30,000 gallons.
*NOTE: Wait 24 hours after shocking before using FROG BAM. Avoid adding other chemicals until this product has been
circulated (filtered) for at least 24 hours.
Remove cap from
FROG BAM® without
removing seal.
seal
Insert upside down into
center of POOL FROG®
Mineral Reservoir
pushing down firmly on
key to puncture seal.
Replace cap by hand only.
DO NOT OVER TIGHTEN.
Turn control dial on POOL
FROG® Mineral Cycler to
Setting MAXIMUM.
Turn pump on for
90 minutes allowing
FROG BAM® to circulate
through pool.
To remove FROG BAM®,
turn pump off. Turn dial to
Setting 0.
Remove POOL FROG®
Mineral Cycler cap.
NOTE: If water shows
more than a hint of blue
inside POOL FROG®
Mineral Cycler, replace the
cap, turn dial to
Maximum and run the
pump for one minute
14a. If pool size requires
additional FROG BAM®,
repeat steps 7-14.
14b. When water is clear
in POOL FROG® Mineral
Cycler, proceed to step
15.
Lift FROG BAM® up and allow any water in the
container to drain through the POOL FROG®
Mineral Cycler before discarding in trash.
11.
12.
13.
10.
14.
POOL FROG®
Mineral Cycler
POOL FROG®
Chlorine Cycler
FROG
BAM
®
POOL FROG®
Mineral Cycler
POOL FROG®
Chlorine Cycler
FROG
BAM®

Related product manuals