144
Terms and abbre-
viations I - P
Terms and abbre-
viations R - 2nd
HCU
Hot-start current
(MMA welding)
HFt
High frequency time
High frequency ignition
Hti
Hot-current time
(MMA welding)
I-E
I (current) - End
Final current
I-G
I (current) - Ground
Ground current
Io
AC current offset
I-S
I (current) - Starting
Starting current
Ito
Ignition time-out
L
L (inductivity)
Displays welding circuit inductivity
nEG
negative
Negative half-wave (TIG AC welding)
PhA
Phase Adjustment
Phase adjustment of the mains connection of two power sources for simultaneous AC
welding
Pos
Positive
Positive half-wave (TIG AC welding)
Pri
Pre Ignition - delayed high frequency ignition
PPU
Push-pull unit
For selecting and calibrating the connected push-pull unit
r
r (resistance)
Determine welding circuit resistance
rPi
reverse polarity ignition
SEt
Setting
Country-specific setting (Standard / USA)
To Next Page
Loading...
