Unit % (of permanently settable parameter AL.1)
Setting range 0 - 30
Factory setting 0
NOTE!
The maximum amount by which parameter AL.1 can be increased or decreased is
the value specified for AL.c.
JSL
Job Slope - defines the time between the job that is currently selected and the next job
Unit s
Setting range OFF or 0.1 - 9.9
Factory setting OFF
Job
t (s)
Job 1
Job 2
Job 1
JSL = OFF
Job 1
JSL = 0,1 - 9,9 s
JSL
Job 2
Job Slope
The value that has been set for Job Slope is stored along with the Job currently selected.
138
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044
To Next Page
Loading...
