Fronius WF 25i REEL R /SA/2R/G/W - Page 33

NOTE!
If the OPT/i WF ext.
start signal installation kit is provided, the unreeling wirefeeder sends a feedback signal
regarding its current status to the robot by way of a relay output.
Before an external start is possible with the OPT/i WF ext. start signal option fitted,
torque mode must first be selected on the wirefeeder by pressing the Mode button.
Feedback signal from the unreeling wirefeeder to the robot = HIGH:
the unreeling wirefeeder is in torque mode.
Feedback signal from the unreeling wirefeeder to the robot = LOW:
the unreeling wirefeeder is in threading mode or a fault has occurred.
33
EN