FS0507T PN 60711000162
·When discharging the waste liquid from this machine, please put it in the container,
and never let it flow to the ground or discard it in rivers, lakes, oceans, etc. Industrial
waste disposal operators should be requested when disposing.
Warning Attention when charging the battery
●When charging, unplug the charger cable (the same reel and extension cable) to
prevent the charging cable from overheating.
●When using the reel and extension cable, please confirm the allowable capacity of
the cable beforehand to avoid overcurrent. In the worst case, it may cause a fire.
●Please charge in a well ventilated area.
●Do not charge near an open flame.
●Check the battery capacity before charging. When the liquid level is lower than
LOWER, please replenish the battery liquid.
●Charging in the absence of battery fluid can cause toxic gases to cause poisoning or
corrode metals in the vicinity of the battery. If this happens, stop charging
immediately.
●When charging, switch the power switch to “Off”.
Note Battery use note
●When checking or replacing the battery, you need to switch the power switch to
“OFF” to cut off the power circuit. The battery terminal must be removed from the
ground side (“-” connector side), and the installation must start from the “+”
connector side.
●Battery fluid (dilute sulfuric acid) poses a risk of blindness or burns. Use protective
glasses, protective gloves, and long-sleeved clothes when using the battery.
●Hydrogen gas is generated in the battery. If the operation is wrong, it will cause a fire
and explosion, so please do not get close to the open flame.
Note Do not wash
●After the electrical system is flooded, it may cause malfunction due to malfunction or
malfunction. For operating panels, solenoid valves, sensors, etc., do not perform
steam cleaning or water washing. If it is necessary to wash the water, please turn off
the main power, fully dry and then turn on the power.
1.7 Safety warning nameplate
1.7.1 Safety warning nameplate list
The following nameplate is posted on the machine.
Please clean these nameplates frequently and keep them clean. If it is damaged or
peeled off, please immediately place it by ordering it at the nearest dealer's or service
center with the part number at the bottom right of the nameplate.
To Next Page
Loading...