FS0507T PN 60711000162
and electric shock personnel who have an electric shock.
To prevent secondary damage, check if the power has been turned off.
Circuit voltage Spacing distance
Low pressure 0~600V 1m or more
High pressure 600~7000V 1.2m Or more
UHV 7000~60000V 2m or more
More than 60,000V 0.2m increase for each additional
10000V
Warning Do not remove the work platform railings
●
Please do not carry out the work after removing the work platform railing, otherwise
there is a danger of falling.
Note It is forbidden to push or pull with walking and lifting machines.
●Please do not use walking or lift operation, push or pull power lines or buildings, etc.
Warning Precautions when setting.
● This machine is not allowed to walk on the general
road according to the regulations.
●Please use it on a flat and sturdy ground.
●When working and walking on uneven ground or
weak ground, there will be the danger of rollover.
●It will be extremely unstable when lifting the
working platform, so please confirm the flatness and
no height Work or walk after the step.
●The ground where the machine is used is inclined,
weak, uneven, and sloped. etc. Please avoid using it.
There is a danger of accidents such as rollovers.
●This unit is forbidden to be used near steps,
inclined surfaces, and openings. May cause
Falling into the steps, slopes, and openings caused
the machine to roll over. If it must be above
When using it in an occasion, please configure the monitor.
●When crossing the steps, please use the slope. The angle of the slope should be
controlled below 7°.
●This machine can ensure that the inclination of safe walking is 7° or less, and it may
cause the machine to roll over when walking above this inclination.
●When walking on a slope of more than 7 degrees, remove the upper control panel
and connect it to the machine via the control line to remotely control the unit.
Warning It is forbidden to board outside the work platform and transfer
To Next Page
Loading...