Trouble Shooting 10
1. Unit not tracking or is fishtailing
2. Unit not tracking: skipping, jumping, and
fishtailing(in untilled, hard soil
3. Unit leaving water furrow in center.
4. Unit ridging or leaving behind a high spot in
center of machine.
5. Unit leaving water furrows on outside of
each rear gang.
6. Blades plugging with soil or trash.
7. Unit leaving a balk between front inside
gangs
A. Adjust top link to increase weight on the rear
of the disc
B. Disc assembled incorrectly. Refer to assem-
bly instructions.
A. Insure equal cut or depth on front and rear.
B. Reduce speed.
C. Reduce gang angle.
D. Reduce depth of cut by carrying on 3 point
lift discing shallow the first time over. NOTE:
Some experimentation may be required by trial
and error to arrive at proper solution.
A. Increase speed.
B. Increase angle on rear gangs.
C. Decrease angle on front gangs.
D. Disc not level. Lower rear gangs or raise
front gangs.
E. Any combination of the above.
A. Decrease speed.
B. Decrease angle on rear gangs
C. Increase angle on front gangs.
D. Disc not level. Raise rear gangs or lower
front gangs.
E. Any combination of the above.
A. Add optional TLT-703-16 outrigger attach-
ments with a round disc blade about 4” smaller
than stock blades.
A. Add optional heavy scraper kit(Page 15).
If already equipped, re-adjust them.
B. Soil conditions not suitable for discing due to
excessive moisture.
A. Add optional TL11477 center sweep balk-
breaker assembly(Page 17).
Gang Adjustment Trouble Shooting
To Next Page
Loading...
