16
How can I program the button to turn on both the TV and STB?
Your remote has separate power buttons for the TV and STB. You can
program the key to turn on/off both your TV and STB at the same time.
1. Turn both your TV and STB on.
2. Press and hold the OK and buttons together, then release both.
• The RED LED will blink twice and then stay on.
3. Press 9 – 7 – 7.
• The RED LED will blink twice and remain on.
4. Press .
• The RED LED will blink three times and then turn off.
5. Test that the button now turns on the TV and STB at the same time.
6.
If you want to reset the remote so that the button controls only the
STB, follow the same steps as above but press OK in Step 4.
What if the Power button on the remote doesn’t always turn my TV on
and off?
Try the following steps:
• Make sure the TV and set-top box are near each other.
• Make sure nothing is blocking the front of either device.
• If your TV is plugged into the power outlet on the back of the set-top box,
try plugging your TV directly into a wall outlet.
• Press the button to control the TV alone.
Control TV Volume through STB
If the volume control keys don’t work with your TV, you can program the
remote so that the STB will control the volume.
1. Press and hold the and OK buttons together, then release both.
• The RED LED will blink twice and then stay on.
2. Press 9 – 5 – 5.
3. The RED LED light will blink twice and remain on.
4. Press .
5. The RED LED will blink three times and then turn off.
6. If you want to change it back again so that volume buttons control the TV,
follow the same steps as above but press in Step 5.
To Next Page
Loading...