Need help?Do you have a question about the FS S1150-8T2F and is the answer not in the manual?
General| Switch Type | Managed |
|---|---|
| Ports | 8 x 10/100/1000BASE-T |
| SFP Ports | 2 x 1G SFP |
| Layer | Layer 2 |
| Switching Capacity | 20 Gbps |
| Forwarding Rate | 14.88 Mpps |
| MAC Address Table | 8K |
| VLAN | 4K |
| Jumbo Frame Support | 9K |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -40°C to 70°C (-40°F to 158°F) |
| Humidity | 10% to 90% non-condensing |
Connect PC to switch using network and console cables.
Recommends Super Terminal, PuTTY, or Secure CRT for switch configuration.
Log into the switch via serial port using specific baud rate and data bits.
Configure switch IP address and PC IP address for system restoration.
Commands to delete startup configuration and reboot the switch.
Steps to recover the switch password, including restarting and viewing files.
Command to display the switch's current configuration file content.
To Next Page
