S3410 SERIES SWITCHES RESET AND RECOVERY SYSTEM CONFIGURATION GUIDE
www.fs.co
UBI: MTD device size: 30 MiB
UBI: number of good PEBs: 240
UBI: number of bad PEBs: 0
UBI: max. allowed volumes: 128
UBI: wear-leveling threshold: 4096
UBI: number of internal volumes: 1
UBI: number of user volumes: 1
UBI: available PEBs: 19
UBI: total number of reserved PEBs: 221
UBI: number of PEBs reserved for bad PEB handling: 2
UBI: max/mean erase counter: 2/0
UBIFS: recovery needed
UBIFS: recovery deferred
UBIFS: mounted UBI device 0, volume 0, name "kernel"
UBIFS: mounted read-only
UBIFS: file system size: 26030080 bytes (25420 KiB, 24 MiB, 205 LEBs)
UBIFS: journal size: 3682304 bytes (3596 KiB, 3 MiB, 29 LEBs)
UBIFS: media format: w4/r0 (latest is w4/r0)
UBIFS: default compressor: LZO
UBIFS: reserved for root: 0 bytes (0 KiB)
Unmounting UBIFS volume kernel!
Uncompressing Kernel Image ... OK
Loading Device Tree to 823fc000, end 823ff745 ... OK
Starting kernel ...
6) You can enter the configuration CLI command line interface without a password at this time.
S3410-24TS-P>enable
S3410-24TS-P#configure
NOTE: After entering the CLI command line interface, if there is no button, the password is required when entering again. The
default timeout is 10min. Please change the password in time before timeout.
7) Change password
2.3 Functional Verification
Log in to the switch again, and log in with the new user name and password to confirm that the login is successful.
To Next Page
Loading...
Need help?
General
