Fuji Electric PEN102J1C - Page 53

34
It changes into the “AUTOSTART after shutdown with alarm” display in
pushing the SET button. Push、▲ button/▼ button when you change the
content display. The content is changed when the SET button is pushed
by the content that changes and it moves to the next item display. Push
the ESC button when it returns to the “AUTOSTART after shutdown with
alarm” item.
・This setting decides whether to start when re-start after shutting down in the
alarm state.
・If UPS shut down with alarm, the mode transfers to the Powerdown in case of
Invalidity.
・When invalidity, ON button recovery is Invalidity.
６-１-９ Polarity
Figure ６-10 Polarity
It changes into the “Polarity” display in pushing the SET button. Push、▲
button/▼ button when you change the content display. The content is
changed when the SET button is pushed by the content that changes
and it moves to the next item display. Push the ESC button when it
returns to the “Polarity” item.
・This setting is a function of installing in the dry contact card of the option.
・An active close becomes REPO ON and REMOTE OFF, When the contact close,
・An active open becomes REPO ON and REMOTE OFF, When the contact open,
CONF I GURAT I ON
POLARITY
POLARITY
ACT I VE CLOSE
POLARITY
ACTIVE OPEN
Factory
Setting
〆