14 Problem Solving
520
Problem Solving
14
116-388
O [Cause] The optional hard disk is not installed.
[Remedy] Install the HDD Extension Kit (optional). Contact our
Customer Support Center.
116-389
O [Cause] The Extension System Memory (optional) is not installed.
[Remedy] Install the Extension System Memory (optional). Contact
our Customer Support Center.
116-700
O [Cause] Memory is insufficient for Image Extension Kit.
[Remedy] Select Standard for the image quality.
116-701
O O [Cause] Unable to use the 2 Sided Printing feature because of
insufficient memory.
[Remedy] Increase memory, or install the HDD Extension Kit
(optional) if it is not installed.
116-702
O [Cause] A print job was processed using a substitute font.
[Remedy] Check the print data.
116-703
O [Cause] An error occurred during PostScript (optional) processing.
[Remedy] Check the print data.
116-708
116-709
O [Cause] An error occurred when reading data on the media.
[Remedy] Use a computer to confirm the content recorded on the
media.
116-710
O [Cause] The correct document size could not be judged because
the receive data exceeded the HP-GL/2 (optional) spool
size.
[Remedy] Increase the size assigned to HP-GL/2 auto layout
memory.
116-713
O [Cause] The job was divided to be printed because of insufficient
disk space.
[Remedy] Delete unnecessary data from the hard disk to free up disk
space.
116-714
O [Cause] An HP-GL/2 (optional) command error occurred.
[Remedy] Check the print data.
116-720
O [Cause] An error occurred during print processing because of
insufficient memory.
[Remedy] Stop unnecessary ports or delete unnecessary data to free
up disk space.
116-725
O [Cause] Failed to write the image log because the image log
storage area on the machine is insufficient.
[Remedy] Execute the operation again.
If this error still is not resolved, take one of the following
measures:
z
Delete unnecessary image logs.
z
Change the [Assurance Level] setting for image logs to
[Low].
In this case, selecting [Low] does not secure the contents
of created image logs.
116-740
O [Cause] A numerical value operation error occurred because a
value exceeding the value limit of the machine was used in
the print data.
[Remedy] Check the print data.
Error Code
Category
Cause and Remedy
CPFSMO
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
