Fuji Xerox apeosport-iv C3371 - Upnp Discovery

Connectivity & Network Setup
177
Tools
5
Important • Do not use the numbers assigned to the other ports.
SNMP
Port Status
Select [Enabled] to use SNMP, when you use any web applications manufactured by Fuji
Xerox to control the machine on the network.
FTP Client
Port Status
Select [Enabled] when you use the Scan to PC service with FTP transmission.
Receive E-mail
Port Status
Select [Enabled] when you receive e-mails or Internet faxes.
Send E-mail
Port Status
Select [Enabled] when you send e-mails or Internet faxes.
E-mail Notification Service
Port Status
Select [Enabled] when you use the E-mail Notification Service. The E-mail Notification
Service notifies you of the machine status or the completion of a print job and a direct fax job
by e-mail.
Note • [Consumables Status], [Parts Status], [Paper Tray Status], [Output Tray Status], [Jam
Status], [Interlock Status], and [Fault Notice] are notified as the machine status.
• You can configure the E-mail Notification Service in CentreWare Internet Services. For more
information, refer to the help of CentreWare Internet Services.
UPnP Discovery
Port Status
Select [Enabled] to use UPnP.
Port Number
Enter a port number for UPnP communication from 1 to 65535.
The default value is 80.
Important • Do not use the numbers assigned to the other ports.
WSD
WSD Print - Port Status
Select [Enabled] to use UPnP.
Set this when you search a device on a network from Windows Vista and Windows 7.
Port Number
Enter a port number from 1 to 65535.
The default value is 80.
Important • Do not use the numbers assigned to the other ports.
Note • WSD stands for Web Services on Devices.
Internet Services (HTTP)
Port Status
Select [Enabled] to use CentreWare Internet Services.
For more information about CentreWare Internet Services, refer to "CentreWare Internet Services
Settings" (P.273).