Stapler Faults
549
Problem Solving
14
4 After you take out the staple cartridge, check
inside of the finisher for any remaining
staples.
5 Pull up the metal part of the staple cartridge
as shown in the illustration.
6 Remove the jammed staples (1), and then
return the metal part pulled up in step 5 to
the original position (2).
7 Push the staple cartridge into the machine
until it clicks into place.
8 Close the finisher front cover.
Note • If the finisher front cover is not completely closed, a message will appear and the machine
remains paused.
CAUTION
Be careful in removing jammed staples.
To Next Page
Loading...
Need help?
General
