Fuji Xerox ApeosPort-VI C7771 - Calling a Stored Program for Build Job

Calling a Stored Program
453
Stored Programming
8
1 Select [Change Settings].
2 Select the [Job Assembly] tab.
3 Select [Stored Programming].
4 Select a number of a stored program containing the features you want to use.
Note
z
You can only select registered numbers.
z
After the stored program has been called, the machine sounds an audible tone. If a failure occurs, the
machine sounds a fault tone.
Reference
z
For information on how to change the volume of the sound that notifies that a stored program has been called, refer to "Tools" >
"Common Service Settings" > "Audio Tones" > "Stored Programming Complete Tone" in the Administrator Guide.